#This file is parsed top to bottom, until the first mount line that matches is found, then it stops.

#Note that I dont support spaces in params
#So if your for example gonna specify idle time use --idle=X not -i X.

#If this is specified program will attempt to drop permissions before running encfs. 
#(will not work with --public for example, as that requires encfs to run as root)
drop_permissions

#This specifies which options to pass to encfs for every user.
#You can find encfs options by running encfs without any arguments
encfs_default --idle=1

#Same for fuse, note that allow_root (or allow_other, or --public in encfs) is needed to run gdm/X.
#you can find fuse options with encfs -H
fuse_default allow_root,nonempty

#For a mount line, - = generic, we try to fill in what we need.
#A Mount line is constructed like this:
#USERNAME		if "-" or "*" gets replaced with $USER
#SOURCE			if USERNAME is -, replace with path + /$USER
#				if USERNAME is *, replace with $HOME/ + sourcepath
#TARGET PATH	if - replace with $HOME
#				if USERNAME is *, replace with $HOME/ + targetpath
#ENCFS OPTIONS	encfs options here is encfs_default + encfs_options
#FUSE OPTIONS	encfs options here is fuse_default + fuse_options

#Keep in mind that the configuration file is parsed top to bottom, so if you put your generic line on top, 
#that will always match before any custom lines under it.


#In this example, with example_user uncommented, the "-" line will never be parsed if you login as example_user.
#In the lines with the USERNAME "*", all paths are relative to $HOME
#USERNAME    	SOURCE 					TARGET PATH      	ENCFS Options		FUSE Options
#example_user	/mnt/enc/example_user	/home/example_user	-v,--idle=1			allow_root
#*				.private				private				-v					allow_other
-				/mnt/enc				- 					-v					allow_other

